493400 IDLE TIMER SOFTWARE
493400 IDLE TIMER PC
493400 IDLE TIMER WINDOWS

This time-out is not recommended for modern standby systems. When this timer expires, the system wakes from ACPI Sleep (S3) and immediately enters ACPI Hibernate (S4) to save power.

493400 IDLE TIMER SOFTWARE

Then the system steps through the preparation phases described in Prepare software for modern sleep. When this time-out occurs, the system enters modern standby and the display is immediately powered down. All applications stop execution because all processors will be powered off. When this time-out occurs, the system immediately enters the ACPI Sleep (S3) state. There is a 5-second grace period between when the display turns off and when the screen off notification is fired. However, the system continues to run and all applications continue to operate normally as if the display was powered on. When this time-out occurs, the display immediately turns off. In Windows 10, the display is automatically dimmed 10 seconds before it is turned off. This time-out is no longer supported starting with Windows 8.1.

493400 IDLE TIMER WINDOWS

This time-out is no longer supported starting with Windows 8.1.

493400 IDLE TIMER PC

The following table summarizes the differences between a modern standby PC and a traditional sleep PC. Instead users would expect the system to stay turned on and connected but operate in a low-power mode. A modern standby PC is similar to a smartphone- few users would tolerate their smartphone periodically turning off and entering hibernation. That's because modern standby is a consistently low-power state with long battery life. Instead, Windows manages Hibernate intelligently, only using it when required to preserve user's battery life. Although Modern Standby systems support Hibernate (S4) state, it is not entered automatically after a fixed amount of time in sleep. Hibernate is used to reduce battery drain during sleep by saving all information in memory to the disk and powering off the system completely. Here’s the problem it solves: I frequently want to switch to a buffer named Shell I’ve formed the habit of typing merely S h e RET, and letting completion complete the buffer name. The following use has vastly improved my life using NTEmacsWithCygwin, for example. Mobile systems also support the ACPI Hibernate (S4) state. The function run-with-idle-timer has a million and one uses. If a user sets the two timeouts to be the same on a modern standby PC, the power model is similar to that used by most smartphones: when the screen is off, the system is always in a low-power mode and always connected to the Internet. The reason for providing two separate time-outs is to allow the system to stay turned on and fully running, but save power by turning off the display. Traditional sleep (S3) and Modern Standby systems implement both a display idle time-out and a sleep idle time-out.

493400 idle timer